Sherman Oaks Ice makers after water work
Taps flowing again upstairs, yet the ice bin stays empty
Plumbing work in a multi-unit building usually means a notice taped by the elevator, a morning without water and then the taps running again. For a Sub-Zero ice maker, that interruption can leave trapped air, loosened grit and sometimes a closed valve behind, and the ice bin stays empty long after the faucet is back to normal.
4.8 out of 5 from 187 reviews Read the reviews
$89 for the trip · house calls 8 AM to 6 PM every day
Why shared plumbing upsets ice makers here
The condos and apartment buildings strung along Ventura Boulevard share risers, pumps and shutoffs, so one repair upstairs can touch every kitchen in the stack.
-
Riser shutoffs for one unit's leak
When a neighbor's valve or water heater needs attention, the whole vertical line may be drained. Your refrigerator was never part of the job, yet its supply line emptied along with everyone else's.
-
Air pockets in long supply runs
In stacked buildings the fridge's feed tubing may travel some distance from the nearest shutoff, sometimes through the cabinet next door to the sink. Refilling it pushes air ahead of the water, and an ice maker reads a fill full of air as a fill that never arrived.
Grit loosened by the restart. Draining and refilling older pipes stirs up scale and sediment. The first rush of water carries it into the cartridge and on to the tiny solenoid that meters each fill.
Valves closed and forgotten. Owners or contractors sometimes close the small valve feeding the refrigerator as a precaution during the work. If nobody reopens it, the ice maker simply waits.
Ice maker stopped working after a water shutoff: why?
Usually air in the line, a supply valve left closed, or sediment that reached the filter or inlet valve when the water came back. Reopen the refrigerator's feed valve if someone closed it, bleed air via a pitcher at the door dispenser where fitted, then allow several harvest cycles. If nothing fills, a part may need attention.
Reading the clues once pressure returns
The pattern of trouble points toward the cause. Match your situation against these pairings prior to swapping any cartridge.
-
No sound of water at all when the ice maker cycles
Points toThe supply valve is closed, or the line is still empty upstream of the refrigerator
-
Sputtering or spitting from the dispenser, then a weak stream
Points toAir still trapped in the line or filter housing
-
Small, hollow or half-formed cubes
Points toFills arriving short because of air, low pressure or a filter partly clogged by grit
-
Cloudy, gray-tinged or odd-tasting first batches
Points toSediment and stale water from the drained line; usually clears once the line has been flushed
-
Trickling into the bin, or a solid slab forming across the tray
Points toAn inlet valve held open by debris after the restart
-
Freezer section also running warm
Points toNot a water problem at all; the cold side needs a look
A restart order for after the water comes back
Go top to bottom. Any puddle, damp cabinet floor or wet baseboard means stop here and phone us.
- Confirm water is back at the kitchen tap Run the cold faucet until it flows smoothly without spurting. If the sink still coughs air, the building line has not fully refilled and the refrigerator will not either.
- Find the valve that feeds the refrigerator Look beneath the sink first, then inside the adjoining base cabinet. Turn its handle all the way open. If it was closed, that alone may be the whole answer.
- Look for drips before anything else Check the visible connection at the valve and, if you can see it safely, behind the toe-kick. A fitting disturbed during the work can weep once pressure returns.
- Purge air through the dispenser, if you have one Where your door has a water paddle, hold a jug under it and keep drawing until the stream runs smooth and clear. This pushes air and loose grit out ahead of the ice maker.
- Make certain icemaking is enabled Some owners or helpers turn it off during the shutoff. Your owner's guide shows where the control sits on your model.
- Consider the filter If cubes stay small after purging, the filter may have caught a slug of sediment. Swap it as your model's use-and-care booklet describes, then bleed the line once more.
Refrigerator water line full of air: how do I clear it?
Dispense water steadily into a pitcher until it stops sputtering and runs clear; units lacking a dispenser push the air through during their opening fills. Before anything, open the feed valve completely. If the line keeps gurgling, a loose fitting or partly clogged filter may be drawing air.
What to expect as production returns
There is no fixed clock for this; timing varies by model, kitchen warmth and the length of the outage. The order of events is fairly predictable, though.
-
Water restored
The building line refills. Air and grit move toward every connected fixture, including the refrigerator.
-
First fill
A fill is requested. Expect a brief, sputtering trickle while trapped air escapes.
-
First harvest
The first cubes drop. Throw these out, along with any older ice left in the bin, since they were made from water that sat in the drained line.
-
Next few batches
Cubes should become fuller and clearer. Discard anything cloudy or off-tasting.
-
Settled
Regular, full-sized cubes and a filling bin. If you never reach this stage, the restart has exposed a part that needs attention.
Getting a technician to the unit
Where can I get a Sub-Zero ice maker repaired in Sherman Oaks?
Calabasas Cooling Experts comes to condos near the boulevard and houses up in the hills to sort out icemakers inside Sub-Zero fridges and freezers. Arrival costs $89, later subtracted from approved work; repair numbers are given after inspection. Lines open 24/7 at (213) 600-7131, or pick a slot via online booking.
Ice questions after a building water shutoff
-
The building says the water work is finished, but my ice maker is still dry. What next?
Start with the valve that feeds the refrigerator, then purge the line through the dispenser if you have one. When the dispenser pours fine while the tray never fills, suspect the icemaker's private plumbing, which calls for a diagnosis.
-
Should I toss the ice that was already in the bin?
Do. Dump everything stored, plus whatever forms during the opening rounds afterward. They can carry sediment and stale water from the drained pipes.
-
Can I pull the refrigerator out to check the line myself?
Built-in Sub-Zero units are fitted into the cabinetry and are heavy. Sliding one out risks the flooring, the panels and the water connection itself. Check what you can reach under the sink and leave the rest to the technician.
-
Is a water shutoff ever the cause of a real failure?
Sometimes. Grit can lodge in an inlet valve and keep it from closing or opening properly, while an aging icemaker sometimes refuses to resume properly. A technician can tell which part is involved.
-
Could your visit include my freezer and fridge too?
Absolutely. We bill $89 once for coming out, regardless of appliance count; individual fixes get quoted after diagnosis, as our pricing explainer describes. Related local pages: freezers in Sherman Oaks and refrigerators in Sherman Oaks.
-
Do you handle ice makers in Encino as well?
Yes. Encino homes are usually single-family, so water issues there have different causes; the Encino ice maker page covers them. For the service itself, see Sub-Zero ice maker repair, and for this area, the Sherman Oaks overview.
Still no ice after the water came back?
Tell us when the shutoff happened, what you have already checked and whether water reaches the dispenser. Coming out costs $89 whether we inspect one Sub-Zero or several; repair figures arrive after diagnosis.